Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

4.5.2 Installing the server in the rack
CAUTION
At least two people are needed to position the server on the rack rails.
(For Japan, see "安全上のご注意".)
For configurations below 32 kg:
At least two people are needed to lift the server into the
rack cabinet.
For configurations below 55 kg:
At least three people are needed to lift the server into
the rack cabinet.
For configurations above 55 kg:
At least four people are needed to lift the server into the
rack cabinet.
Additionally, a lifter is required in the following cases:
–
The server weighs more than 50 kg.
–
The server weighs more than 21 kg and is to be installed above the height of
25 U.
When using a lifter, this installation procedure needs to be carried out by
maintenance personnel.
Basic hardware procedures
RX1330 M4 Upgrade and Maintenance Manual 53

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller