Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

PCI slot Riser module Type Description
3 Riser module 3 PCIe Gen3 x8
(mechanical x8)
Low-profile slot, maximum
length 167.65 mm
As an option a full height riser module can be installed, see "Upgrading
to the full height riser module" on page 214. In this case the slot 2 is not
available and slot 3 can be equipped with a full height expansion card.
For system relevant information, see the hardware configurator of your
server available online at the following address:https://ts.fujitsu.com/
products/standard_servers/index.htm
For Japan:
https://www.fujitsu.com/jp/products/computing/servers/primergy/
9.3
Handling slot brackets
9.3.1 Installing slot brackets
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Use the low profile bracket perforated for relevant controllers.
Expansion cards and backup units
RX1330 M4 Upgrade and Maintenance Manual 185

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller