Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

For more information on iRMC settings, see the iRMC user guides.
Clearing the SEL using the iRMC S5 web interface
▶
Log in to the iRMC S5 web interface.
▶
Open the Logs menu.
▶
Click System Event Log to open the System Event Log page.
All events concerning the system are displayed in a table in the Event Log
Content group.
▶
Click the Clear Logs button above the table to clear the SEL.
For more information on iRMC settings, see the iRMC user guides.
Collecting logs using the Infrastructure Manager
The Infrastructure Manager can collect various logs including System Event
Log for system operation and maintainance.
Please refer to the following manuals of Infrastructure Manager for
collecting logs from ISM.
See manual "FUJITSU Software Infrastructure Manager V2.6.0 User's
Guide", section "2.5 Log Management", available at:
https://ts.fujitsu.com/support/
For Japan:
See manual "FUJITSU Software Infrastructure Manager
V2.6.0 解説書",
section "2.5 ログ管理機能", available at:
https://www.fujitsu.com/jp/products/software/infrastructure-software/
infrastructure-software/serverviewism/technical/
5.3.13 Updating the NIC configuration file in a Linux and
VMware environment
In order to prevent errors caused by changing network device names (eth<x>),
it is recommended to store the MAC address (hardware address) of a network
Basic software procedures
RX1330 M4 Upgrade and Maintenance Manual 85

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller