13 Front panel
13.1 Safety notes
CAUTION
▶
When inserting the front panel module into the server, ensure not to
pinch or strain any connected cables.
▶
Circuit boards and soldered parts of internal options are exposed
and can be damaged by static electricity. Always discharge static
build-up (e.g. by touching a grounded object) before handling
electrostatic-sensitive devices (ESDs).
▶
Do not touch the circuitry on boards or soldered parts. Hold circuit
boards by their metallic areas or edges.
▶
For more information, see
"Important information" on page 29.
13.2 Basic information
In case of a defective ambient temperature sensor, please replace the front
panel.
Front panel module
The front panel module consists of a holder and a front panel board. These
components are already pre-assembled. The USB connector of the front USB
cable must be installed in the dependant recesses of the holder
. As an option
the holder can be equipped with a front VGA connector.
Front panel on QRL (10x 2.5-inch HDD configuration)
The front panel on QRL (Quick Release Lever) is only available for the servers
with a 10x 2.5-inch HDD configuration. The front panel is mounted on the right
QRL. A flat cable is used for connection to the system board.
RX1330 M4 Upgrade and Maintenance Manual 267
To Next Page
Loading...
