Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

For configurations below 32 kg:
At least two people are needed to lift the server out of
the rack cabinet.
For configurations below 55 kg:
At least three people are needed to lift the server out of
the rack cabinet.
For configurations above 55 kg:
At least four people are needed to lift the server out of
the rack cabinet.
Additionally, a lifter is required in the following cases:
–
The server weighs more than 50 kg.
–
The server weighs more than 21 kg and is to be removed above the height
of 25 U.
When using a lifter, this removal procedure needs to be carried out by
maintenance personnel.
Basic hardware procedures
50 Upgrade and Maintenance Manual RX1330 M4

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller