Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

are available from the Fujitsu support internet pages at:
https://ts.fujitsu.com/support/
For Japan:
https://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/
Note on the boot watchdog
Before updating or recovering the BIOS and iRMC, ensure that the boot
watchdog is disabled, see "Disabling the boot watchdog" on page 66.
After updating or recovering the BIOS and iRMC, enable the boot
watchdog again, see "Enabling the boot watchdog" on page 80.
Fujitsu does not assume responsibility for any damage done to the
server or for the loss of any data resulting from BIOS updates.
BIOS flash procedure
▶
Perform the BIOS flash procedure as described in the "BIOS Setup Utility"
reference manual of your server.
BIOS recovery procedure
▶
Perform the BIOS recovery procedure as described in the "BIOS Setup
Utility" reference manual of your server
.
Updating the iRMC firmware
▶
Enter the ServerView iRMC web interface.
▶
Select the Tools menu.
▶
Select Update to open the Update page.
▶
Select iRMC Update.
▶
In the iRMC Update group click Select to search the new firmware.
▶
Select the new firmware and click Start Update.
For more information on iRMC settings, see the iRMC user guides.
Basic software procedures
70 Upgrade and Maintenance Manual RX1330 M4

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller