Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

–
information depending on the configuration:
– installed HDD/SSD backplanes
–
installed extension boxes
– installed expansion cards (for example Retimer, EP5xxi)
In order to integrate your system into the ServerView Management
environment and to enable server installation using the ServerView Installation
Manager, system information needs to be completed and corrected.
System information has to be updated after one of the following tasks:
–
Front panel module
– replacing (with the same type)
– changing (from front panel module 2.5-inch to front panel on QRL)
–
HDD/SSD backplane (2.5-inch, 3.5-inch, PCIe)
– installing
– removing
– changing (the technology, for example from SAS/SATA to PCIe)
–
Extension boxes
– installing
– removing
–
Specified expansion cards (for example Retimer, EP5xxi)
– replacing
–
Converting the server
– from rack model to floorstand model
– from floorstand model to rack model
Update your system information using the Chassis ID Prom tool. The tool and
more information are available to maintenance personnel from the Fujitsu web
pages:
https://partners.ts.fujitsu.com/com/service/ps/Servers/PRIMERGY/
▶
Select your PRIMERGY system from the main area of the page.
▶
From the categories selection, choose Software & Tools Documentation.
Basic software procedures
92 Upgrade and Maintenance Manual RX1330 M4

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller