Fujitsu PRIMERGY RX2560 M2 - Looking up MAC Addresses; Looking up WWN Addresses

138 Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Basic software procedures
5.2.17.1 Looking up MAC addresses
Ê
Enter the ServerView iRMC web frontend.
Ê Select the System Information menu.
Ê Under Network Inventory , you will find detailed information on each network
controller in the managed PRIMERGY server, including its MAC address.
I This information is only available with the iRMC S4 or above.
Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
Ê Inform the customer about the changed MAC address.
5.2.17.2 Looking up WWN addresses
Emulex FC / FCoE adapters
Ê
Enable the network controller’s Option ROM in the system board BIOS as
described in section "Enabling Option ROM scan" on page 123.
Ê Restart the server.
Ê During boot, as soon as the Emulex BIOS utility option appears, press
[ALT] + [E] or [CTRL] + [E] .
Ê Under Emulex Adapters in the System you will find all available Emulex
adapters and their WWN addresses.
Ê Note down the new 16-digit WWN address.
Ê Press [Esc] to exit the Emulex BIOS utility.
Ê Inform the customer about the changed WWN address.
QLogic FC adapters
Ê
Enable the network controller’s Option ROM in the system board BIOS as
described in section "Enabling Option ROM scan" on page 123.
Ê Restart the server.
Ê During boot, as soon as the QLogic BIOS utility option appears, press
[ALT] + [Q] or [CTRL] + [Q] .
Ê Under Select Host Adapter use the arrow keys æ / Ë to select the desired
FC / FCoE adapter and press
[Enter] .