Fujitsu PRIMERGY RX2560 M2 - Ultraslim ODD in 4 x 3.5-inch HDD Extension Box

418 Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Accessible drives
12.6 Ultraslim ODD in 4x 3.5-inch HDD extension
box
12.6.1 Installing the ultraslim ODD
12.6.1.1 Preliminary steps
Ê
"Shutting down the server" on page 58
Ê "Disconnecting the power cord" on page 59
Ê "Getting access to the component" on page 61
I The front cover only needs to be removed in order to remove
accessible drive dummy covers. If the HDD extension box is already
installed in the server and will be removed in order to install an
ultraslim ODD, skip this step.
Ê "Removing the system air duct" on page 91
Ê "Removing the system fan holder" on page 93
Ê "Removing a riser module" on page 98 (if applicable)
Ê "Removing the 4x 3.5-inch HDD extension box" on page 251 (if applicable)
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools:
– Phillips PH2 / (+) No. 2 screw driver
– Slotted screw driver (for bending in or out accessible drive
mounting brackets)