Fujitsu PRIMERGY RX2560 M2 - Removing the SAS Expander Board; Preliminary Steps; Removing the Expander Holder

TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual 279
Hard disk drive (HDD) / solid state drive (SSD)
7.7.2 Removing the SAS expander board
7.7.2.1 Preliminary steps
Ê
"Suspending BitLocker functionality" on page 111
Ê "Shutting down the server" on page 58
Ê "Disconnecting the power cord" on page 59
Ê "Getting access to the component" on page 61
Ê "Removing the system air duct" on page 91
Ê "Removing the system fan holder" on page 93
7.7.2.2 Removing the expander holder
Ê
Disconnect all cables from the SAS expander board.
Figure 194: Removing the expander holder
Ê Remove the screw (see circle).
Ê Take the expander holder out of the chassis.
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools:
Phillips PH2 / (+) No. 2 screw driver