Fujitsu PRIMERGY RX2560 M2 - Concluding Steps; Replacing the SAS Expander Board (Configuration with up to 32 HDD;SSD Modules); Preliminary Steps; Removing the SAS Expander Board

200 Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Hard disk drive (HDD) / solid state drive (SSD)
7.2.14.4 Concluding steps
Ê
"Installing the system fan holder" on page 94
Ê "Installing the system air duct" on page 92
Ê Install all removed HDD/SSD modules as described in sections "Installing a
2.5-inch HDD/SSD module" on page 174.
Ê "Reassembling" on page 74
Ê "Connecting the power cord" on page 87
Ê "Switching on the server" on page 90
7.2.15 Replacing the SAS expander board (configuration
with up to 32 HDD/SSD modules)
7.2.15.1 Preliminary steps
Ê
"Locating the defective server" on page 55
Ê "Shutting down the server" on page 58
Ê "Disconnecting the power cord" on page 59
Ê "Getting access to the component" on page 61
Ê "Removing the system air duct" on page 91
Ê "Removing the system fan holder" on page 93
7.2.15.2 Removing the SAS expander board
Ê
Remove the SAS expander holder as described in section "Removing the
SAS expander holder" on page 191.
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools:
Phillips PH2 / (+) No. 2 screw driver