Fujitsu PRIMERGY RX2560 M2 - Concluding Steps; Preliminary Steps; Replacing the Irmc Microsd Card

480 Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
System board and components
Ê Pull the iRMC microSD card straight out of its slot (2).
V CAUTION!
The iRMC microSD card contains customer information. After removing
the iRMC microSD card, hand the card over to the customer.
14.6.2.3 Concluding steps
Ê
If applicable, install the riser module 2 as described in section "Installing a
riser module" on page 95.
Ê "Reassembling" on page 74
Ê "Connecting the power cord" on page 87
Ê "Switching on the server" on page 90
14.6.3 Replacing the iRMC microSD card
14.6.3.1 Preliminary steps
Ê
"Locating the defective server" on page 55.
Ê "Shutting down the server" on page 58.
Ê "Disconnecting the power cord" on page 59.
Ê "Getting access to the component" on page 61
Ê If applicable, remove the riser module 2 as described in section "Removing
a riser module" on page 98.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools:
a pair of side-cutting pliers