Fujitsu PRIMERGY RX2560 M2 - Installing the Dummy Cover; Concluding Steps

342 Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Expansion cards and backup units
Ê If no new DynamicLoM module will be installed:
Ê Remove the three bolts (see figure 248).
Ê Fasten the system board screw (see figure 246).
9.5.3.3 Installing the dummy cover
Figure 251: Installing the dummy cover
Ê Insert the dummy cover. Notice the position of the handle.
9.5.3.4 Concluding steps
Ê
If applicable, install the riser module 1 as described in section "Installing a
riser module" on page 95.
Ê "Reassembling" on page 74
Ê "Connecting the power cord" on page 87
Ê "Switching on the server" on page 90
Ê "Enabling SVOM boot watchdog functionality" on page 130