Fujitsu PRIMERGY RX2560 M2 - Removing Memory Modules

TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual 361
Main memory
10.3 Removing memory modules
10.3.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 111
Ê "Disabling SVOM boot watchdog functionality" on page 112
Ê "Locating the defective server" on page 55
Ê "Shutting down the server" on page 58
Ê "Disconnecting the power cord" on page 59
Ê "Getting access to the component" on page 61
Ê "Removing the system air duct" on page 91
10.3.2 Removing a memory module
Ê Identify the desired memory slot see section "Basic information" on
page 350.
V CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Basic information" on page 350.
Figure 258: Removing memory modules (A)
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory slot.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools:
tool-less