Fujitsu PRIMERGY RX2560 M2 - Replacing the Serial Interface; Preliminary Steps; Removing the Defective Serial Interface; Installing the New Serial Interface

348 Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Expansion cards and backup units
9.6.3 Replacing the serial interface
9.6.3.1 Preliminary steps
Ê
"Disabling SVOM boot watchdog functionality" on page 112
Ê "Locating the defective server" on page 55
Ê "Shutting down the server" on page 58
Ê "Disconnecting the power cord" on page 59
Ê "Getting access to the component" on page 61
9.6.3.2 Removing the defective serial interface
Ê
Remove the serial interface as described in section "Removing the serial
interface" on page 347.
9.6.3.3 Installing the new serial interface
Ê
Install the serial interface as described in section "Installing the serial
interface" on page 345.
9.6.3.4 Concluding steps
Ê
"Reassembling" on page 74
Ê "Connecting the power cord" on page 87
Ê "Switching on the server" on page 90
Ê "Enabling SVOM boot watchdog functionality" on page 130
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools:
nut driver 5 mm