TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
307
Expansion cards and backup units
Ê
Remove the rear air grid.
V CAUTION!
Keep the rear air grid for future use.
Always install rear air grids into unused installation locations to
comply with applicable EMC regulations and satisfy cooling
requirements.
Ê
Remove the slot cover of PCI slot 3 as described in section "Removing the
slot cover" on page 296.
Figure 214: Removing the slot cover lock from the holder
Ê
Remove the screw (see circle).
Ê
Remove the slot cover lock.
Ê
Install up to three expansion cards in the riser module as described in
section "Installing expansion cards in riser modules" on page 308.
9.3.4.3 Concluding steps
Ê
"Installing a riser module" on page 95
Ê
"Reassembling" on page 74
Ê
Reconnect all external cables to the installed expansion cards.
Ê
"Connecting the power cord" on page 87
To Next Page
Loading...
