Fujitsu PRIMERGY RX2560 M2 - Concluding Steps; Removing Expansion Cards from Riser Modules; Preliminary Steps; Removing an Expansion Card

312 Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Expansion cards and backup units
Ê If applicable, fasten the slot cover lock with the screw at the rear side (see
figure 215).
9.3.5.6 Concluding steps
Ê
"Reassembling" on page 74
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the power cord" on page 87
Ê "Updating RAID controller firmware" on page 122
Ê "Enabling Option ROM scan" on page 123
Ê "Enabling SVOM boot watchdog functionality" on page 130
Ê "Resuming BitLocker functionality" on page 136
Ê If applicable, "After replacing / upgrading LAN controllers" on page 140
9.3.6 Removing expansion cards from riser modules
9.3.6.1 Preliminary steps
Ê
"Suspending BitLocker functionality" on page 111
Ê "Shutting down the server" on page 58
Ê "Disconnecting the power cord" on page 59
Ê Remove all external cables from the expansion card to be removed.
Ê "Getting access to the component" on page 61
9.3.6.2 Removing an expansion card
Ê
Remove the slot cover lock as described in section "Removing the slot cover
lock" on page 309.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools:
Phillips PH2 / (+) No. 2 screw driver