TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
491
System board and components
Ê
"Looking up changed MAC / WWN addresses" on page 137
Ê
"Updating the NIC configuration file in a Linux and VMware environment" on
page 134
Ê
"Enabling SVOM boot watchdog functionality" on page 130
Ê
"Resuming BitLocker functionality" on page 136
Ê
Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I
Configuration of network settings should be performed by the
customer. For further information, please refer to section "Note on
network settings recovery" on page 484 and section "Software
configuration" on page 340.
Ê
If applicable, restore LAN teaming configurations as described in section
"After replacing the system board" on page 140.
To Next Page
Loading...
