3
1. How to Install the VDR Maintenance Viewer,
Connect the PC
1.1 Installation by CD (supplied)
Live Player V4 and the VDR Maintenance Viewer Program are included in the accessory
CD. Install these programs in the PC.
Note: Do not change the default installation folder.
1. Place the CD in the PC CD drive.
2. The contents of the CD are displayed in a window. Double click on the file “view.exe”.
The Installation Wizard opens.
3. Follow the directions of the Installation Wizard.
The Live Player V4 and Maintenance Viewer are installed in the computer. The Live
Player V4 is not required for use here.
1.2 Installation in a Windows 7 PC (32 bit only)
This section provides the procedure for the installation of the VDR Maintenance Viewer in
a Windows 7 PC.
Deactivate the firewall
Temporarily deactivate the Windows 7 firewall to install and operate the VDR
Maintenance Viewer.
1. Open the Control Panel.
2. Select Network and Internet.
3. Select Network and Sharing Center.
4. Select Windows Firewall from the left window.
5. Select Turn Windows Firewall on or off from the left window.
6. At Public network location settings, select Turn off Windows Firewall (not
recommended) then click the OK button.
If you try to use the VDR Maintenance Viewer with the firewall active, the following
occurs:
VDR settings cannot be downloaded when the Live Player V4 is connected.
Data cannot be replayed when the Backup HDD is connected to LAN. Data extraction
and analysis also are not possible.
VDR settings cannot be downloaded or updated from the VDR Maintenance Viewer.
To reactivate the firewall, select Turn on Windows firewall at step 6 in the procedure.
To Next Page
Loading...
Need help?
General
