Furuno VR3000 - How to Set the PC

4
How to install the VDR Maintenance Viewer software
1. Double click VR-3000_ver*.exe. (* is version number).
2. The Setup – VR-3000 dialog box appears; click the Next button.
3. Confirm that the install location is C:\Program Files then click the Next button.
4. The Folder Exists dialog box appears; click the Yes button.
5. After the Folder Exists dialog box disappears, click the Next and Install buttons.
6. After the installation is completed, the message "Yes, restart computer now" is
checked then click the Finish button.
How to grant administrator rights
Run the VDR Maintenance Viewer program as an Administrator to use full function of the
program.
1. Click the Start button, select All Programs and check that "VR-3000" appears.
2. Select LivePlayerV4 at VR-3000, right click, then select Properties.
3. Select Compatibility from the Live Player V4 Properties dialog box.
4. At Privilege Level, check Run this program as an administrator.
5. Select MaintenanceViewer at VR-3000, right click, then select Properties.
6. Select Compatibility from the menu in the MaintenanceViewer Properties dialog
box.
7. At Privilege Level, check Run this program as an administrator then click the OK
button.
1.3 How to set the PC
Before connecting to VR-3000/VR-3000S, set the IP address and subnet mask of the PC
as below. The IP address of VR-3000/VR-3000S is 10.0.0.100.
Windows XP
1. Click Start, Settings, Control Panel and Network Connections.
2. Click Local Window Network, Properties and Internet Protocol (TCP/IP).
3. Click the Properties button.
4. Choose “Use the following address”.
5. Enter IP address and subnet mask:
IP address: 10.0.0.102 or 10.0.0.99 (other than 10.0.0.100).
Subnet mask: 255.0.0.0.
6. Click the OK button and then click it again.
Windows Vista
1. Click Start, Control Panel, Network and Internet, Network and Sharing Center.
2. Click View status to show the Local Window Connection Status dialog box and click
the Properties button.
3. Select Internet Protocol Version 4 (TCP/IP v4) and click the Properties button.
4. Select "Use the following IP address" and enter IP address and subnet mask:
IP address: 10.0.0.102 or 10.0.0.99 (other than 10.0.0.100).
Subnet mask: 255.0.0.0.
5. Click the OK button and then click it again on the next screen.
6. Restart the PC.