FUTABA T6K-V2 - V-Tail Mixing (V-TAIL)

149
Glider
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+
keyfor1second.
＋
② Select
fromthemenuwiththe
Jogkey.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
1AIL 2AIL1AIL1FLP 2AIL1FLP 2AIL2FLPWINGTYPE
V-TAIL
V-Tail
(GLIDER)
This mixing is used with V tail aircraft that com-
bine the elevator and rudder functions.
"V-TAIL"
Activatingthefunction
ELE2rate
ELE4rate
RUD2rate
RUD4rate
● WhenINHisselected,thefunc-
tioncannotbeused.Tousethe
function,selectACT.
（Rateadjustment）
● Selectthesettingitemwith
theJogkey.
■ Activatingthefunction
①Selectthe"MIX"itemandthen
selectthe"ACT"bypressing
the+keyor‒key.
＋ −
or
● Whenyoudonotusea
function,settothe"INH"side.
■ Rateadjustment
＋ −
or
②Selectthevalueitemandthenadjust
themixingratebypressingthe+keyor
‒key.
Range：-100to+100%
Default：+50%
（onlyELE4:-50%）
● Whenyouwanttoreturnthesetvaluetotheinitialvalue,press
the+keyand‒keysimultaneously.However,polaritydoesnot
return.
NOTE：Werecommendthatsettingbeperformedwhilemovingthestickandcheckingtheamountof
movement.Iftheamountofmovementistoolarge,elevatorandrudderoperationwillbecompoundedandthe
servotravelrangewillbeexceededandadeadbandinwhichtheservowillnotoperatemaybecreated.
V-TAIL
ElevatorUP ElevatorDOWN RudderRight RudderLeft
CH2(CH4)
(Stickmode2)
CH4(CH2)