110 232003110G (03)
Machine Setting- Others Page
The Others Page allows you to change various settings that correspond to the control panel. The
Language setting will allow users to change available languages displayed on the control panel.
The Unit setting will allow you to change whether the units displayed by the Touch Screen is in the
metric or imperial system. The EOF (end of file) Alarm setting will enable or disable an audible
notification when jobs are complete. The Air Delay setting allows you to specify the delay in
seconds of the SmartAIR air-assist after the point of laser firing.
• Language: ENGLISH (others dependent on Firmware)
• Unit: METRIC/ INCH
• EOF Alarm: YES/ NO
• Air Delay: 1-100 seconds
T
i
p
Depending on the material you are working with, your laser settings, and the
desired results, please experiment with the air delay to achieve your desired
results.
Save your current settings
To Next Page
Loading...
