GCC Technologies LaserPro S400 - Page 156

154 232003110G (03)
Polish
Dust will accumulate during the engraving when acrylic is engraved. The acrylic can be polished after the
engraving. After the processing, don’t remove the engraved object. Use the Touch Screen to lower the platform (for
about 7~8 mm) and then engrave once again to achieve the better finish.
You are welcome to clink below link for easy understanding:
https://www.youtube.com/watch?v=qFXTC5dSYwg&feature=youtu.be
After engraving the wooden objects, please use a toothbrush with some clean water to remove the dust on top of
the object.