GCC Technologies LaserPro S400 - Page 99

97 232003110G (03)
Machine Setting Page
The Machine Setting Page allows you to access and modify various machine settings, including: Set Lens,
Tune Auto Focus, Set Table Down, Red Beam on/ off, Carriage Free, select Command Mode, File Save, Set
Stabdby mode, Save position, Select Vector Mode, LAN setup Wizard, Scaling, Other, and Reset etc.
Machine Setting Page
Relevant Buttons
Function
Back
Back to previous page
Home
Go back to Main work page
Prev File
Go back to previous file
Next File
Go to next file
Main Work Page
Functions Page
Navigating to this page:
Machine Setting Page