Troubleshooting: Monitor defaults transfer
2000966-542D Dash 3000/4000/5000 6-11
Monitor defaults transfer
Below is a list of error messages that may display when performing a
patient monitor defaults transfer.
Storing monitor defaults
Copying stored monitor defaults
Message Description
ERROR - UNIT DEFAULTS HAVE NOT
BEEN SAVED
Patient monitor defaults were not saved on
the server patient monitor due to a memory
error in the patient monitor.
Message Description
ERROR COPYING UNIT DEFAULTS -
NETWORK ERROR
Either an error has occurred while the
defaults were being transferred, or defaults
have not been saved on the server patient
monitor.
ERROR COPYING UNIT DEFAULTS -
UNIT TYPE MISMATCH
The server and client patient monitors are
set to different unit types (e.g., ADULT,
NEO, or OR)
ERROR COPYING UNIT DEFAULTS -
SOFTWARE VERSION MISMATCH
The server and client patient monitors have
different software versions (e.g., V2C, V3A).
ERROR COPYING UNIT DEFAULTS -
DATA CORRUPTION ERROR
The patient monitor defaults transferred have
become corrupted, possibly due to a
memory error.
ERROR COPYING UNIT DEFAULTS -
SOFTWARE FEATURE LEVEL
MISMATCH
The server and client patient monitors are
set to different software levels (e.g., Basic,
Cardiac, Cardiopulmonary).
ERROR COPYING UNIT DEFAULTS -
COUNTRY CODE MISMATCH
The server and client patient monitors are
set to different country codes (e.g.,
DEFAULT or FRANCE).
To Next Page
Loading...
