Electromagnetic compatibility (EMC): Electromagnetic compatibility (EMC)
A-2 Dash 3000/4000/5000 2000966-542D
Electromagnetic compatibility (EMC)
Changes or modifications to this system not expressly approved by GE
can cause EMC issues with this or other equipment. This system is
designed and tested to comply with applicable regulation regarding EMC
and must be installed and put into service according to the EMC
information stated in this supplement.
CAUTION
Use of portable phones or other radio frequency (RF)
emitting equipment near the system may cause
unexpected or adverse operation.
CAUTION
The equipment or system should not be used adjacent to,
or stacked with, other equipment. If adjacent or stacked
use is necessary, the equipment or system should be
tested to verify normal operation in the configuration in
which it is being used.
Guidance and manufacturer’s declaration – electromagnetic
emissions
The Dash 3000/4000/5000 is intended for use in the electromagnetic
environment specified below. It is the responsibility of the customer or
user to assure that the Dash 3000/4000/5000 is used in such an
environment.
Emissions test Compliance Electromagnetic environment – guidance
RF Emissions (radiated)
CISPR 11
Group 1
Class A
The equipment uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
RF Emissions (conducted)
CISPR 11
Group 1
Class A
Harmonic Emissions
IEC 61000-3-2
Class A CAUTION
The equipment is suitable for use in all establishments other than domestic and
those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Voltage Fluctuations/
Flicker Emissions
IEC 61000-3-3
Complies
To Next Page
Loading...
