LOGIQ e – Basic Service Manual Index-1
5461614-100 English Rev. 6
Index
A
abbrevations, 9-2
acclimate time, 2-3
Admin screen
Logon, 10-7
approved
internal peripherals, 3-21
approved internal peripherals, 3-21
average setup time, 3-3
B
before installation (site preparations), 2-1
Boot Up, 3-14
C
cable inspection
mains cable inspection, 10-20
care and maintenance, 10-1
warnings, 10-8
CE compliance, 1-31
change history, i-1
chapter 1
introduction, 1-1
chassis leakage current test, 10-33
cold or hot
if the unit is very cold or hot, 2-3
compatibility
hardware/software, 9-3
completing the setup, 3-12
compliance, 1-31
configuration, 3-19
connect
probe, 3-17
console environmental requirements, 2-3
console requirements, 2-3
contact information, 1-33
contents in this manual, 1-3
conventions used in book, 1-7
copyrights, i-14
customer assistance, 1-33
phone numbers, 1-34
customer order
verification, 3-11
customer provided prerequisite, 8-13
D
damage in transport, i-11
dangerous procedure warnings, 1-28
data network setup requirements, 2-16
desirable features, 2-14
DICOM network function, 2-16
DICOM setup requirements, 2-17
disconnect
probe, 3-18
display PDF files
from manual CD-ROM
print PDF files
from manual CD-ROM, 4-15
E
electrical requirements, 2-6
EMI limitations
EMI limitations, 2-9
general requirements, 2-6
power stability requirements
power stability requirements, 2-7
power transients
power transients, 2-7
site circuit breaker
site circuit breaker, 2-7
site power outlets
site power outlets, 2-7
specific requirements for the unit, 2-6, 3-21
unit power plug
unit power plug, 2-7
voltage drop-out
voltage drop-out, 2-7
electrical safety, 1-24
electrical safety tests, 10-26
electrical specification, 3-13
electromagnetic interference
abatement, 2-10
prevention, 2-10
electrostatic discharge prevention, 1-32
EMC, 1-31
compliance, 1-31
what is EMC?, 1-31
EMI, 1-31
abatement, 2-10
prevention, 2-10
protection, 3-11
To Next Page
Loading...
Need help?
General
