Revision C MAC 1200/1200 ST 10-15
2012250-021
System Setup: Stress Test Mode
When the cursor is in the bottom line of the command menu, it can be
positioned in the table with . When the cursor moves beyond the
borders of the screen, the table position changes accordingly. The column
listing the stage names, however, does not change so that users will not
lose track of the stage they are in.
With the key combinations
+ , + , + , +
the table can be repositioned by the width/height of a full screen.
Editing Parameters
Position the cursor on the value to edit and press .
Enter the new value and confirm the entry with .
Adding a Phase
A phase can only be added when there are less than 3 phases to the
protocol. The phase names begin in column 1, the stage names in column
2. A new phase is always added before the phase where the cursor is
currently located (the cursor may be located on any stage).
1. Push .
The cursor moves to the command menu.
2. Position the cursor on [add phase] and confirm with .
A list with the existing phases appears.
3. Select the desired phase and confirm with . The phase is added
to the table.
Alt Alt Alt Alt
To Next Page
Loading...
Need help?
General
