viii G60 Generator Protection System GE Multilin
INDEX
SERIAL PORTS
Modbus registers ...........................................................B-18
settings ......................................................................... 5-16
SETTING GROUPS .......................... 5-114, 5-130, 5-220, B-29
SETTINGS TEMPLATES
description................................................................ 4-4, 8-6
editing ...................................................................... 4-4, 8-6
enabling ................................................................... 4-4, 8-6
Modbus registers ...........................................................B-65
password protection.................................................. 4-5, 8-7
removing .................................................................. 4-7, 8-9
viewing..................................................................... 4-6, 8-8
SETTINGS, CHANGING ................................................... 4-26
SIGNAL SOURCES
description.......................................................................5-5
metering ........................................................................ 6-15
settings ......................................................................... 5-73
SIGNAL TYPES..................................................................1-3
SINGLE LINE DIAGRAM.............................................. 2-1, 2-2
SITE LIST, CREATING .......................................................4-1
SNTP PROTOCOL
error messages................................................................7-9
Modbus registers ...........................................................B-20
settings ......................................................................... 5-37
SOFTWARE
installation.......................................................................1-5
see entry for ENERVISTA UR SETUP
SOFTWARE ARCHITECTURE ............................................1-4
SOFTWARE, PC
see entry for EnerVista UR Setup
SOURCE FREQUENCY .................................................... 6-18
SOURCE TRANSFER SCHEMES.................................... 5-185
SOURCES
description.......................................................................5-5
example use of .............................................................. 5-74
metering ........................................................................ 6-15
Modbus registers ...........................................................B-22
settings ................................................................ 5-72, 5-73
SPECIFICATIONS ............................................................ 2-10
SPLIT PHASE PROTECTION
FlexLogic™ operands .................................................. 5-114
logic ............................................................................ 5-184
Modbus registers ...........................................................B-32
settings ....................................................................... 5-181
specifications................................................................. 2-11
ST TYPE CONNECTORS ................................................. 3-26
STANDARD ABBREVIATIONS ............................................F-9
STATOR DIFFERENTIAL
actual values ................................................................. 6-14
characteristic ............................................................... 5-147
description................................................................... 5-147
FlexLogic™ operands .................................................. 5-114
logic ............................................................................ 5-148
Modbus registers ..................................................B-10, B-29
settings ....................................................................... 5-147
specifications................................................................. 2-10
STATOR GROUND
see also entry for 100% STATOR GROUND
actual values ................................................................. 6-22
Modbus registers ..................................................B-11, B-32
settings ....................................................................... 5-203
STATUS INDICATORS ............................................ 4-14, 4-16
STORAGE TEMPERATURE.............................................. 2-23
SUB-HARMONIC STATOR GROUND FAULT
FlexLogic™ operands .................................................. 5-114
settings ....................................................................... 5-209
specifications................................................................. 2-12
SURGE IMMUNITY .......................................................... 2-24
SYMMETRICAL COMPONENTS METERING .....................6-12
SYNCHROCHECK
actual values.................................................. 6-9, 6-19, 6-22
FlexLogic™ operands ...................................................5-115
logic ............................................................................5-236
Modbus registers.................................................. B-13, B-23
settings............................................................. 5-233, 5-234
specifications .................................................................2-13
SYNCHROPHASORS
actual values..................................................................6-24
commands ...................................................................... 7-4
FlexLogic™ operands ........................................ 5-112, 5-113
network connection ......................................................5-105
phase measurement unit triggering .................................5-98
phasor measurement configuration ........................5-91, 5-95
phasor measurement unit ......................................5-89, 5-90
phasor measurement unit calibration ...............................5-97
phasor measurement unit recording ..............................5-105
test values ...................................................................5-279
SYSTEM FREQUENCY .....................................................5-72
SYSTEM SETUP ..............................................................5-70
T
TARGET MESSAGES ........................................................ 7-6
TARGET SETTING ............................................................ 5-5
TARGETS MENU ............................................................... 7-6
TCP PORT NUMBER ........................................................5-35
TELEPROTECTION
actual values................................................................... 6-5
clearing counters............................................................. 7-2
FlexLogic™ operands ...................................................5-115
logic ............................................................................5-263
Modbus registers........................................................... B-45
overview ......................................................................5-261
settings.................................................... 5-67, 5-261, 5-262
specifications .................................................................2-18
TEMPERATURE MONITOR.................................... 5-117, 7-10
TERMINALS ...................................................................... 3-8
TESTING
force contact inputs ......................................................5-277
force contact outputs ....................................................5-278
lamp test......................................................................... 7-3
self-test error messages .................................................. 7-6
synchrophasors............................................................5-279
THD
Modbus registers........................................................... B-15
THD METERING ............................................. 2-16, 6-18, 6-19
analog channel correspondence......................................5-44
THERMAL OVERLOAD PROTECTION
Modbus registers........................................................... B-35
settings........................................................................5-245
specifications .................................................................2-14
THIRD HARMONIC NEUTRAL UNDERVOLTAGE
FlexLogic™ operands ...................................................5-109
logic ............................................................................5-208
Modbus registers........................................................... B-31
settings........................................................................5-207
specifications .................................................................2-12
TIME ................................................................................. 7-2
TIME OVERCURRENT
see PHASE, NEUTRAL, and GROUND TOC entries
TIMERS .........................................................................5-124
TOC
ground .........................................................................5-169
neutral .........................................................................5-162
To Next Page
Loading...
