8-8 MIB High Impedance Bus Differntial Relay GEK-106426B
8.8 RELAY SETTING 8 RELAY COMMISSIONING
8
8.8RELAY SETTING
When the relay is shipped from the factory, it comes with a default set of settings, which act as the starting point for the
following tests.
Since the MIB relay has a large number of settings, a list of all the settings necessary for all tests will not be given here, but
rather only the specific settings required for each test indicated.
These tests are only valid for the default factory configuration. Different configurations involving modifications in certain
elements, such as different contact configuration, will require a subsequent modification of the test procedure.
To Next Page
Loading...
