2–30 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
GETTING STARTED CHAPTER 2: GETTING STARTED
VLAN
VLAN: Global Settings Enable/disable VLAN functionality.
VLAN: VIDs Assign VLAN IDs and view properties (tagged/untagged) of existing
VIDs.
VLAN: Port Settings Assign ports to VLANs and set properties (mode, tagged/untagged)
Serial Tasks
Ports
Ports: Profiles Create a profile (10 attributes) for later assignment to a serial port.
Ports: Settings Enable and disable serial ports and assign profiles.
Ports: Statistics Monitor the performance of a serial port.
Terminal Server
Terminal Server: Channel
Settings
Add or remove terminal server channels.
Terminal Server: Channel
Status
View the status of configured terminal server channels.
Terminal Server:
Connections
Check status of currently active TCP/IP connections.
Modbus
Modbus: Global Settings Enable/Disable Modbus management
Modbus: Fixed Mappings configure fixed mappings between serial ports and TCP port numbers
Modbus: Local Masters Configure a Modbus local master.
Modbus: Local Slaves Configure a Modbus local slave.
Modbus: Remote Slaves Configure a Modbus remote slave.
Modbus: Connections Monitor Modbus connections.
IP Tasks
Settings Configure IP addresses for the system.
ARP Table View and flush the Address Resolution Protocol (ARP) table.
QoS Tasks
DiffServ Configure DiffServ Code Point (DSCP) priorities.
802.1p Assign Ethernet frames to priority queues based on 802.1p markings.
Ethernet Port Assign a priority rule to a specific Ethernet port.
IP Flows Associate specific IP packet flows with DiffServ markings.
Table 2–2: Menu Tree
Screen Function
To Next Page
Loading...
