Section 4 — Measurement Types and their Uses
87
11. Press again once the plot has stabilized — A single waveform
orbit measurement displays.
NOTE: Filtering is NOT supported on your instrument. You can use
Ascent for advanced analysis.
12. Press Save to save the two waveform measurements used to
generate the orbit plot.
NOTE: You must specify the vertical and horizontal channels in
order to correctly view the orbit plot in Ascent.
NOTE: The circle icon indicates the start position of the waveform.
The triangle indicates the end.
13. Press Change View to toggle between orbit plot and waveform
views.
Orbit plot
To Next Page
Loading...
