DIRECTION 5854713-100, REVISION 2
VENUE FIT™ SERVICE MANUAL
Chapter 3 - System Setup 3-23
PRELIMINARY
On the Connectivity tab, enable the required settings in the Connectivity items list, by moving the On/
Off sliders to On. Then, select each Connectivity item to define its properties. Tap Apply and then
Save.Then, proceed to the next tab.
Figure 3-13 Venue Fit™ Installation Wizard - Connectivity Tab
On the OptionKey tab, enter the key string to enable the purchased options and tap Save. Then,
proceed to the next tab.
Figure 3-14 Venue Fit™ Installation Wizard - Option Key Tab
To Next Page
Loading...
