GE Vivid q N - Page 108

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
3-36 Section 3-7 - Completing the Hardware Installation
3-7-2-3 DVD/CD-RW Drive
NOTE: The procedures in Section 3-7-2-3-1 and 3-7-2-3-2 describe replacement of the Samsung
DVD/CD-RW drive (Model SE-TO84M/RSBN).
NOTE: .If replacing a new-type Samsung DVD/CD-RW drive (Model SE-TO84M/RSBN) with a new one
of the same model, prior to the procedure it is necessary to order the DVD Kit (P/N S2423870
- Table 3-1). Depending on the condition of the existing cables, it also may be necessary to
order the Samsung Cable Kit (S2423956) - see Table 3-2.
NOTE: If replacing only cables, it is only necessary to order the Samsung Cable Kit (S2423956) - see
Table 3-2.
The Samsung DVD SE-TO84M/RSBN Kit (P/N S2423870) includes the following:
The Samsung cable kit for DVD SE-TO84M/RSBN (P/N S2423956) includes the following:
Table 3-1 Samsung DVD SE-TO84M/RSBN Kit (P/N S2423870)
Part No Part Description
RS2423870 Samsung DVD SE-TO84M/RSBN
R2423877 DVD Patch CD
2418071INS Pocket DVD with USB Installation Guide
Table 3-2 Samsung Cable Kit (S2423956)
Part No Country
RS2423951
2 Port USB cable Vivid i n SafeLock Cart
R2423953
5V Medical Grade AC Adaptor
R24123781
DVD to Distribution USB Cable
NOTICE
IMPORTANT - the following steps must be performed in the order stated.
(If the USB cable is connected first while power to the Vivid q N is ON, the drive will not be recognized.
In this event, it will be necessary to re-boot the system).
CAUTION
Do not disrupt power to the Samsung DVD-R/RW drive from its AC/DC adapter while the USB
cable is connected to the Vivid q N system.
In this event, the system will stop recognizing the CD/DVD drive or any other device connected
to this USB port. A complete system re-boot will then be required to make the USB port
operational again.
NOTICE
IMPORTANT: Use only CD-R, DVD-R or DVD+R media from a reputable vendor and only high-grade
media types.