GE Vivid q N - Page 162

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
3-90 Section 3-10 - Connectivity Setup
3-10-2-4 Wireless USB Network Configuration
3-10-2-4-1 Installing the Compact Wireless-G Adaptor Software
1.) Connect the DVD-CD RW drive to the Vivid q N system as described in Section 3-7-2-3 on page
3-36.
2.) Insert the Wireless USB driver P/N 5391287 identified with the GE label in the DVD drive.
3.) Boot up the system in maintenance mode and navigate to Windows Explorer.
4.) Create a new folder on the system’s D drive and name it WIFI DRIVER.
5.) Copy the contents of the disk to the WIFI DRIVER folder.
6.) Disconnect the DVD drive from the system.
7.)
Plug the wireless USB device connected to the R-adaptor into the USB port at the rear of the
VividqN system. Refer to Figure 3-28 on page 3-35 .
The New Hardware installation wizard opens, as shown in Figure 3-89.
8.) Select "No, not this time" (Figure 3-89), and click Next.
Figure 3-89 New Hardware Installation Wizard