GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-12 Section 8-2 - External Component Replacement Procedures
8-2-4-5 Control Panel and Keyboard Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the
appropriate movie clips previously referenced in the Control Panel and Keyboard Removal
Procedure.
NOTE: When installing the Control Panel and Keyboard during other replacement procedures, Step 1
will only be required if indicated.
1) Stand the replacement Control Panel and Keyboard beside the Vivid q N system and tilt it on its
side to gain access to the cable connector underneath. Re-connect the keyboard/control panel
cable from the system to the cable connector (refer to Figure 8-16, above).
2.) Carefully lift the Control Panel and Keyboard into position on the Vivid q N (refer to Figure 8-15,
above). Make sure it is properly seated and take care to align the screw holes with those in the
Bottom Assembly.
3.) Close the Vivid q N LCD Display cover, making sure both front latches are securely fastened.
4.) Carefully turn the Vivid q Nover, placing it face down.
5.) Return and fasten each of the 9 screws that secure the Control Panel and Keyboard onto the
Bottom Assembly (refer to Figure 8-14, above).
6.) Re-install the battery as described in the "Battery Installation Procedure" on page 8-5.
7.) Return the Handle as described in the "Bearing Handle Installation Procedure" on page 8-3.
8.) Reconnect the AC adapter and all cables to the Vivid q N portable ultrasound scanner.
9.) Proceed to perform the following functionality tests:
- "SafeLock Cart - Grounding Continuity" on page 10-22 - only if the Vivid q N system is
currently mounted on the SafeLock cart
- "SafeLock Cart - Chassis Current Leakage Test" on page 10-24
- "Isolated Patient Lead (Source) Leakage – Lead-to-Ground" on page 10-26
- "Isolated Patient Lead (Source) Leakage – Lead-to-Lead" on page 10-27
- "Isolated Patient Lead (Sink) Leakage - Isolation Test" on page 10-27
- "Alphanumeric Keyboard Test" on page 4-19
- "External Keyboard Test" on page 4-20
- "Trackball Test" on page 4-22
- "Calibration Tests" on page 7-25
To Next Page
Loading...
