GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-44 Section 8-3 - Internal Component Replacement Procedures
8-3-3-5 BEP Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the
appropriate movie clips previously referenced in the BEP Removal Procedure.
NOTE: The SATA BEP has an adaptor bracket, which is required for its installation. The bracket is
shown on the left in Figure 8-52; in the picture on the right, the bracket is shown in position in
the Vivid q N scanner. Notice that the bracket sits on the PCMCIA slot-flap, which is pressed
open while the adaptor bracket is positioned on the flap itself. To install the adaptor bracket, the
flap is pressed open (Figure 8-53) and the adaptor bracket is placed in position. The procedure
is described below.
Figure 8-52 SATA Adaptor Bracket
Figure 8-53 PCMCIA Slot Flap Pressed Open
SATA Adaptor Bracket
SATA Adaptor Bracket PCMCIA Slot Flap
PCMCIA Slot Flap Ready for Positioning the Adaptor Bracket
To Next Page
Loading...
