GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-45
8-3-3-5-1 Preparation Procedure
1) Press the PCMCIA slot-flap open and hold it down as shown in Figure 8-53.
2.) Place the adaptor bracket in position as shown on the right in figure Figure 8-52 and press it firmly
against the Vivid q N chassis.
NOTE: Figure 8-54 shows a view from the rear of the Vivid q N showing the adaptor bracket closing off
the PCMCIA slot.
3.) Connect the control panel/keyboard cable (if previously removed from an ATA BEP; see Figure
8-51) to the SATA BEP.
Proceed to install the SATA BEP as described in the next procedure.
8-3-3-5-2 BEP Installation
1) Carefully return the new BEP to the original position on the Bottom Assembly - refer to Figure 8-50
on page 8-43.
NOTE: When replacing the BEP or Hard Disk, one must either obtain new access codes that will fit the
system ID which is programmed on the BEP, or program the BEP system ID to fit the access
codes already registered in the Hard Disk. Only qualified personnel should perform these tasks.
2.) Check that the BEP is seated correctly then return and fasten the four screws (previously removed)
to secure the BEP to the Bottom Assembly - refer to Figure 8-48 on page 8-42.
3.) Re-connect all the cables to the BEP:
Proceed as follows (refer to Figure 8-47 on page 8-41):
a.) Re-connect the Speaker-to-BEP power cable
b.) Re-connect the Fan-to-BEP power cable.
c.) Re-connect the HVPS-to-BEP power cable.
d.) Re-connect the BEP-to-RFI Flex cable.
e.) Re-connect the LCD Flex ribbon cable (carefully push back and secure the two connector
latches).
4.) Return and fasten the two securing nuts previously removed (one on each side of the VGA
Connector, located on the Vivid q N rear panel), as shown Figure 8-46.
5.) Return the Control Panel and Keyboard, as described in the "Control Panel and Keyboard
Installation Procedure" on page 8-12.
6.) Return the Hard Disk, as described in the "Hard Disk Installation Procedure" on page 8-7.
Figure 8-54 Rear View of the Vivid q N Scanner after SATA BEP Installation
VGA Connector
Adaptor Bracket
(external view)
Hard Disk shown without
its retaining screws
To Next Page
Loading...
