Gema OptiCenter OC09 - Ultrasonic Sieve System US07-1; Sieve Machine PS07-1

Rev. 00 02/21
24

Product description OptiCenter OC09
Is there no powder hopper, the ball valve must be closed.
Ultrasonic sieve system US07-1**
The US07-1 Ultrasonic sieve system with the corresponding Ultrasonic
sieve generator is used for the ultrasonic supported sieving of coating
powder. It is exclusively used inside the OptiHopper.
The system is delivered from the factory with a mesh size of 250 µm.
Additional mesh sizes are available: 140 µm, 200 µm, 300 µm, 500 µm
and 1180 µm.
The sieve configuration and sieve selection are done on the Touch Panel.
fig.
15
:
For additional information, please see the operating instructions
of the ultrasonic sieve system!
Sieve machine PS07-1**
The sieve machine is used for the vibration supported sieving of coating
powder and can be equipped with different mesh sizes and sieve covers
(see separate operating instructions).
It is exclusively used above the OptiHopper powder hopper.
The sieve is configured via the Touch Panel.
fig.
16
:
For additional information, please see the operating instructions
of the sieve machine!