Rev. 00 02/21
70
Maintenance / Repairs OptiCenter OC09
Cleaning Steps
Manual cleaning is supported by automated procedures. The OptiCenter
offers the following automated procedures:
Collecting powder
Cleaning the ring injector (AirMover) / powder hose (in
direction to the booth)
Cleaning the powder hoses (in direction to the guns)
Cleaning the powder hoses (in direction to the pumps)
The following functions are available for fine cleaning:
Strong fluidization of the fluidization plate
Cleaning Times
All cleaning steps are time controlled. However, the factory-set values can
be individually adjusted according to the requirements for cleanliness.
1. In cleaning mode, press the key
2. Adjust cleaning time(s)
Cleaning procedure
1. End the coating procedure
2. To exit Coating mode, press and hold the key for 2 seconds.
The following menu appears on the display:
To Next Page
Loading...
