Rev. 00 02/21
66
Operation OptiCenter OC09
11. Empty the used powder bag with the residual powder into another
container or dispose of it
12.
If an error message appears, correct the error and acknowledge it
to ensure that the coating process continues to run!
Color change
To perform a color change, proceed as follows:
1. End the coating procedure
2. Clean the OptiCenter
– See chapter "Cleaning procedure" on page 70.
3. Fill the cleaned OptiHopper with new color
– See chapter "Filling the OptiHopper" on page 60.
4. Select the desired operating mode
If an error message is displayed, correct the error and
acknowledge the error message so that the coating process
continues.
To Next Page
Loading...
