Gema OptiCenter OC09 - Functions Available at User Level; CAN Bus; General; User Administration

Rev. 00 02/21
36

Touch panel / operating panel OptiCenter OC09
– User level 4 (user 3)
These user levels are pre-programmed and cannot be changed.
The functions available depending on the user level are explained below.
Functions available at user level
User
Admin
Gema
Service
user 1
user 2
user 3
User level
0
1
2
3
4
User groups
Administ
rator
Service
Supervis
or
Operator
Painter
The panel can be used without any
limitation

–
–
–
–
Level for trained Gema personnel


–
–
–
Configuration possible

–
–
–
–
Plant parameters can be modified



–
–
If no user is logged on to the panel,
operation is locked
–
–
–
–
–
CAN bus
General
The control is a CAN master system. Together with CAN slave
participants, it forms the network.
The wiring and topology of the CAN network is specified in the electrical
diagram.
User administration
Status display
The login status is displayed in the corresponding bar:
User logged in
User logged out
Login
The user can log in as follows:
– By clicking on the symbol in the login status bar , if another user
has previously logged out