Rev. 00 02/21
OptiCenter OC09 Disposal
89
Disposal
Introduction
Requirements on personnel carrying out the
work
The disposal of the product is to be carried out by the owner or operator.
When disposing of components that are not manufactured by Gema, the
instructions in the respective manufacturer’s documentation must be
observed.
Disposal regulations
The product must be disassembled and disposed of properly at
the end of its service life.
► When disposing of the product, the applicable local and regional
laws, directives and environmental regulations must be
complied with!
Materials
The materials must be sorted according to material groups and taken to
the appropriate collection points.
Disassembly of component groups
Live components
Risk of fatal injury from electric shock if touched
► Only trained, authorized staff may open the electrical
compartment
► Observe the safety symbols
1. Disconnect the mains supply and supply cables.
2. Remove all product covers.
The product is now prepared for disassembly.
To Next Page
Loading...
