Gema OptiCenter OC09 - Displacer; Powder Feed to Guns; Level Sensor

Rev. 00 02/21
OptiCenter OC09 Product description

25
Displacer**
fig.
17
:
– Coating process can be started with only 6 kg of powder
– Easy to install (small rework required in the OptiHopper)
– Easy to clean due to no-stick materials
If there is no displacer, 11 kg of powder is required to start the
coating process.
Powder feed to guns**
– Powder feed to guns from powder bag cone or original powder
container
– Use up to max. 2 guns
– Fluid/suction lance(s)
– Not included in the cleaning procedure of the OptiCenter
– For manual, simple coating tasks
Fig.
18
Level sensor**
– For level detection in the powder bag cone or in the powder hopper
– Height adjustable
– Fluidized in the measuring range