Rev. 00 02/21
OptiCenter OC09 Touch panel / operating panel
35
the procedure of these cleaning modes, there is no difference, only the
preset parameters are different (cleaning times). The higher the
requirement for cleanliness, the higher the time expenditure will be.
Each of these cleaning modes consists of several parts.
The cleaning of the components is partially automated, however, some of
them must be cleaned manually.
The Cleaning operating mode can be selected from every coating
operating mode, or from the Standby operating mode.
Utilization of this operating mode:
– After switching on the plant, if very high quality is required on initial
coating application
– Before every color change
– Before switching off the plant
The higher the requirement for cleanliness, the higher the time
expenditure will be.
During cleaning, no objects may be present in the booth and no
objects may enter the booth.
Configuration
This operating mode allows logged in operators to make certain
configurations on the OptiCenter and to change parameters.
Settings
This operating mode allows logged in operators to make certain settings
on the control unit or to read information:
– User administration
– Operator and system language
– Brightness, date/time, communication, diagnostics, network
– Information regarding operating hours, hardware and software
User levels and access
The user does not have to be logged in to operate the OptiCenter
with its basic functions.
The plant control offers the possibility to define the access rights of the
different users. Access is only possible after entering the appropriate
password. Certain functions are available depending on the user level,
which is defined in advance.
The software has 5 user levels as standard predefined by Gema:
– User level 0 (admin)
– User level 1 (Gema service)
– User level 2 (user 1)
– User level 3 (user 2)
To Next Page
Loading...
