Rev. 00 02/21
64
Operation OptiCenter OC09
To prevent the powder collection unit (under the cyclone) from overfilling,
the fresh powder supply is delayed by parameter 3460. This ensures that
priority is given to recovering the powder from the powder collection unit
before fresh powder is introduced into the powder cycle. After the delay,
the OptiHopper is simultaneously filled with the fresh and recovery
powder until the powder level is reached.
The coating is correctly set when the powder collection unit
(under the cyclone) does not overfill.
– This must be set with parameter 3460.
fig.
:
(See chapter "Parameter description" on page 56.)
Working interruptions or coating breaks
If the coating process is interrupted for a longer period of time, the system
should be brought into an economical state.
1. Check if all the workpieces have been coated
2. Press the key for 2 seconds
– The Coating menu is closed and switches back to the main
menu
– The level control is switched off
– The vibrator switches off
Switching off the OptiCenter (after each working day)
To shut down, the following steps must be taken:
1. Check if all the workpieces have been coated
2. Press the key for 2 seconds
– The Coating menu is closed and switches back to the main
menu
– The level control is switched off
– The vibrator switches off
To Next Page
Loading...
