Gema OptiCenter OC09 - Page 58

Rev. 00 02/21
58

Start-up OptiCenter OC09
No.
Parameters
Description
Value
3462
Supervision Level sensor
stops powder circuit
If in automatic mode the powder level set in
parameter 3440 is not reached after the set
time has elapsed, the powder feed of fresh
and recovery powder is stopped for safety
reasons (overfill protection) and an error
message is triggered.
2.0-10.0
min
3465
Supervision Fresh powder
demand FPS
If in automatic mode the powder level set in
parameter 3440 is not reached after the set
time has elapsed, the powder feed of fresh
and recovery powder is stopped for safety
reasons (overfill protection) and an error
message is triggered.
0.3-5.0 min
3471
Extend sieve
15-60 s
3481
Level sensor cleaning off
10-30 s
3482
Level sensor cleaning on
0.3-3.0 s