Rev. 00 02/21
OptiCenter OC09 Operation
61
2.
3. After the reposition, the coating screen shows the selected device
configuration:
In this example, the configuration is displayed with a fresh powder
system and covered level sensors and the sieve is switched on.
4. If a US sieve** has already been configured, insert and close the
OptiHopper cover with the appropriate mesh size
– If there are several mesh sizes, the corresponding menu
appears for selecting the mesh size used
Overheating of the US sieve**
The US sieve can break if it has already been configured in the
configuration menu and is not inserted in the OptiHopper (dry
operation).
► Insert US sieve into the OptiHopper
Clogging of the US sieve**
The US sieve can become clogged if it has not been configured in
the configuration menu and is still inserted in the OptiHopper
(operation without or with insufficient sieving capacity).
► Set US sieve parameters correctly
To Next Page
Loading...
