V 09/18
OptiStar CG06 Automatic gun control unit Operating and display elements • 25
General information
Displaying the programs
The number of the adjusted program is shown on display A5. A
P=Program is placed in front of the three digit program number as a ref-
erence.
Displaying the values
Displaying the actual values
The actual values are shown on the displays A1-A4. By operating the
keys T1-T8 and T12-T15, preset values display will be switched over.
Display of the preset values/setting values
The preset values are shown on the displays A1-A4. If no operation
takes place during 3 seconds, the actual values displayed will be
switched over.
Edit and save the preset values
The preset values can be adjusted in steps by ± 1 with the keys T1-T8.
Modified preset values are saved automatically, after 2 seconds, in the
current program.
Change between program and application mode
Pressing the keys T10 and T11 in one of the three predefined application
modes (Preset mode), causes the unit to change to user-defined pro-
grams. These keys also allow the change of programs in the program
mode.
The simultaneous operation of the + and - key on the back of the powder
gun (OptiSelect gun) causes the control unit to rotate between the Preset
mode and the Program mode.
Viewing of preset values
To change from the actual value to the preset value display without
changing a preset value at the same time, the corresponding keys must
be lightly touched.
Example:
Lightly touching key T1 indicates the preset values, pushing harder on
this key, reduces the powder output. This behavior does not apply to the
program select keys, where the program number is directly changed.
To Next Page
Loading...
