V 09/18
OptiStar CG06 Automatic gun control unit General safety regulations • 5
General safety regulations
This chapter sets out the fundamental safety regulations that must be fol-
lowed by the user and third parties using the OptiStar CG06 Automatic
gun control unit.
These safety regulations must be read and understood before the Op-
tiStar CG06 Automatic gun control unit is used.
Safety symbols (pictograms)
The following warnings with their meanings can be found in the Gema
operating instructions. The general safety precautions must also be fol-
lowed as well as the regulations in the operating instructions.
DANGER!
Danger due to live electricity or moving parts. Possible consequences:
Death or serious injury
ATTENTION!
Improper use of the equipment could damage the machine or cause it to
malfunction. Possible consequences: minor injuries or damage to equip-
ment
NOTE!
Useful tips and other information
Conformity of use
1. The OptiStar CG06 Automatic gun control unit is built to the lat-
est specification and conforms to the recognized technical safety
regulations. It is designed for the normal application of powder
coating.
2. Any other use is considered as non-conform. The manufacturer
is not responsible for damage resulting from improper use of this
equipment; the end-user alone is responsible. If the OptiStar
CG06 Automatic gun control unit is to be used for other purposes
or other substances outside of our guidelines then Gema Swit-
zerland GmbH should be consulted.
3. Observance of the operating, service and maintenance instruc-
tions specified by the manufacturer is also part of conformity of
To Next Page
Loading...
